We’re often asked by customers how to treat air ducts? They’re certain they have pests like SPRINGTAILS or SILVERFISH living in the duct but are concerned about spraying a chemical where air will be flowing out.
In fact any pests exiting around air ducts, electric outlets, light switch covers or light fixtures are most likely coming from the wall, attic or ceiling space above. In other words, they’re not likely to be nesting in the air duct or even using it.
In this short video, you’ll get to see how this can happen; basically there is a space between the air duct and the hole which allows pests to enter.
So for entry points on the wall or floor, the FS MP injected under the covering will work fine and is easy to apply. For ceilings OR if you want a permanent application that will last at least as year, use the DEMISE DUST.
Use a CRUSADER HAND DUSTER as shown in the video to apply the dust.
HOW TO TREAT WALLS AND CEILINGS
But what if you want to treat the walls and ceiling? This can be done and for many pests, required.
The first option is our MULTIPURPOSE AEROSOL. This product is water based and when lightly misted over walls and ceilings, won’t stain like FS MP can if over applied.
The following “short video” (less than 60 seconds long) shows how to use it on walls and ceilings.
Also shown in the video above was BITHOR and our MINI-MISTER. The Mini Mister will pump out a super light aerosol that can be sprayed on walls too so if you have this setup, its more cost effective compared the aerosol.
In either case, both can be used to safely spray walls and ceilings without making a mess.
If you have a lot of wall space to treat, the MINI MISTER with BITHOR will be the way to go.
This short video shows how the Mini Mister works to create a light aerosol.
Using the odorless Bithor, you can safely and effectively treat most anywhere in the home making the Mini Mister a great tool for “in the home” treatments.
RECENT COMMENTS